1. gzyueqian
      13352868059
      首頁 > 新聞中心 > > 正文

      NXP ISP1506 ULPI收發器的解決方案

      更新時間: 2009-09-10 18:46:41來源: 粵嵌教育瀏覽量:1711

       NXP公司的ISP1506是4位雙向ULPI收發器,能為ASIC和FPGA器件提供高速USB模擬前端解決方案,從而實現高速USB主機接口,外設接口和OTG接口.

              ISP1506評估板為設計者提供了評估ISP1506的特性,以及進行系統級的確認和測試.本文介紹了ISP1504評估板的主要性能,連接器和詳細的應用電路圖.

              The ISP1506 is a 4-bit bidirectional UTMI+ Low Pin Interface (ULPI) transceiver, which provides a Hi-Speed Universal Serial Bus (USB) analog front-end solution to Application-Specific Integrated Circuits (ASICs) and Field Programmable Gate Arrays (FPGAs) to implement as a Hi-Speed USB host, peripheral or OTG device. 

              The ISP1506 evaluation (eval) board allows you to evaluate the features of the ISP1506 for performance measurement and functionality characterization. The eval board also allows the ULPI Transceiver and Macrocell Tester (T&MT) interface to be connected to a USB link to validate the transceiver. 

              Fig 1 shows the ISP1506 eval board.

              2.1 功能

      Fully complies with Universal Serial Bus Specification Rev. 2.0 
      On-chip 1.5 kΩ pull-up resistor on DP and 15 kΩ pull-down resistors on DP and DM; optional external 1.5 kΩ low-speed pull-up resistor on DM provided on-board
      On-chip 45 Ω resistors on DP and DM for high-speed termination
      All UTMI+ static signals are accessed using register map
      60 MHz clock out (4-bit DDR data interface that clocks on both the rising and falling edges of the clock), can be configured to drive 60 MHz from the USB link on the same pin
      Supports full-speed and low-speed UTMI+ serial interface
      Supports high-speed, full-speed and low-speed disconnect detection
      4-bit DDR data bus that allows USB packet transaction and register access
      Supports UTMI+ OTG interface with an internal 50 mA charge pump, or an external VBUS switch or charge pump; an external solution must be used for VBUS current requirements higher than 50 mA.

            2.2 連接器
      USB connectors: standard-A, standard-B and mini-AB
      ULPI through T&MT connector
      Input power connector. 

            2.3 電源

      The board power can be directly supplied from an external power supply or from a link through the T&MT connector.

      The VBUS power supply is generated from the on-chip charge pump or from the link through the T&MT connector.


      圖1.ULPI T&MT卡方框圖



      圖2.ISP1406評估板電路圖.


      圖3.ISP1406評估板電路圖(2).

            表1.ISP1406評估板元器件清單(BOM):




           點擊此處查看詳情

      免費預約試聽課

      亚洲另类欧美综合久久图片区_亚洲中文字幕日产无码2020_欧美日本一区二区三区桃色视频_亚洲AⅤ天堂一区二区三区

      
      

      1. 亚洲乱码中文欧美第一页 | 亚洲伊人久久久综合 | 婷婷丁香五月激情亚洲综合 | 在线看片免费人成视频手机观看 | 亚洲国产另类精品专区 | 日本中文字幕在线2020 |